Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Start of the engine after a partition

Once again check up levels of impellent oil and cooling liquid. Be convinced that have connected all wires and hoses and have not left in an impellent compartment any tools and rags.

PETROL MODELS

START

1. Remove spark plugs, disconnect a control system of the engine (remove a safety lock "M" of protection from the block of safety locks in an impellent compartment, pay attention that through it the safety lock also moves a food to the mechanism of an emergency tension of a seat belt and systems of a pillow of safety, notes and preventions in Section System of a tension of seat belts of forward seats - the general information therefore see and the System of pillows of safety - the general information and safety measures and Removal and installation of components of pillows of safety Has undressed). Turn the engine a starter, the control lamp of pressure of oil will not go out yet. 2. Establish spark plugs and the fuse. 3. Start the engine, remembering that on it can be demanded a bit more time, than usually. 4. Examine the idling engine on presence of leaks of fuel, water and oil. At the first start probably occurrence of a smoke and a smell of burning caused by burning out of greasing. 5. Allow to the engine to idle, while on the top hose hot water will not begin to flow, then muffle it. 6. Having waited some minutes, repeatedly check up levels of oil and cooling liquid and finish them to norm as required (the routine maintenance Schedule see). 7. On all engines except F7R there is no necessity repeatedly to tighten bolts of fastening of a head of the block of cylinders. 8. If new pistons, rings or bearings коленвала have been established, to the engine is necessary обкатка. On the first 800 km of run do not include full gas and do not overload it on low turns. After обкатки it is recommended to replace oil and the filter.

DIESEL MODELS

START

1. Fill fuel system as it is described in the Head of the Power supply system and release. 2. On models with turbocharger, fill greasing system, disconnecting the valve отсечки fuel from the fuel pump and turning the engine a starter for 10 seconds with pauses in 30 seconds. In summary, connect the valve отсечки fuel (check up that the control lamp of pressure of oil lighted up at starter inclusion). 3. Press against the stop a gas pedal, turn a key in the ignition lock in position "M" and wait, the control lamp of heating will not go out yet. 4. Start the engine. 5. As soon as the engine will earn, support it in a mode of fast idling. Track, that the control lamp of pressure of oil has gone out, then check up, that there were no leaks of oil, fuel and a cooling liquid. Where it is applied, check up connecting муфты the steering hydraulic booster. 6. Support the engine in an idling mode, yet will not feel a stream of a hot cooling liquid through the top hose of a radiator specifying in achievement of normal working temperature. Then switch off the engine and allow to it to cool down. 7. Repeatedly check up levels of oil and cooling liquid and finish them to norm if it is necessary (see the routine maintenance Schedule). 8. Check up the moment of injection and idling turns as it is described in the Head of the Power supply system and release. 9. On models with turbocharger, tighten bolts of fastening of a head of the block of cylinders the moment of a final stage of an inhaling, preliminary having warmed up the engine to normal working temperature (the cooling fan should join), and then having waited not less than 2 hours that it has cooled down. 10. If new pistons, rings or bearings коленвала have been established, to the engine is necessary обкатка. On the first 800 km of run do not include full gas and do not overload it on low turns. After обкатки it is recommended to replace oil and the filter.