Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
- Engine repair
+ Repair of petrol engines of 1.4 l and 1.6 l in an impellent compartment
+ Repair of petrol engines of 2.0 l in an impellent compartment
+ Repair of the diesel engine in an impellent compartment
- Procedures of removal and engine major repairs
Methods of removal of the engine and precaution
Removal and installation of the petrol engine and manual transmission
Removal and installation of the petrol engine and automatic transmission
Removal and installation of the diesel engine and transmission
Sequence of dismantling - an engine partition
Dismantling of a head of the block of cylinders
Cleaning, survey and service of a head of the block of cylinders and valves
Assemblage of a head of the block of cylinders
Removal, check of a condition and installation of a flywheel/privodnogo of a disk
Replacement left (the flywheel/privodnogo of a disk located from outside) an epiploon of a cranked shaft
Removal and pallet installation картера (only for petrol engines of series К7М with the aluminium pallet)
Removal and installation of an intermediate shaft
Removal of assemblage of pistons/rods
Removal коленвала
Cleaning and survey of the block of cylinders/kartera and cylinders
Survey and assemblage of assemblages of pistons/rods
Survey коленвала
Survey of radical bearings
Balance of assembly - an engine partition
Check of a working backlash of radical bearings and installation коленвала
Check of a working backlash шатунных bearings and installation - assemblages of pistons/rods
Start of the engine after a partition
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
|
Dismantling of a head of the block of cylinders
|
|
Considering that for removal and head survey special tools be required, it is recommended to get the new or restored component at experts in an engine partition. Finally it can leave cheaper, than is independent touch a head. |
|
|
On engines F7R final valves contain sodium for heat exchange improvement. These valves CANNOT be THROWN out with internal contents. It is better to cut them half-and-half and to dip into water (for 4 valves 10 litres is required). Observe necessary security measures. |
PETROL ENGINES
|
|
|
1. Remove an axis коромысел (engines 1.4 and 1.6), cam-shafts and pushers. |
|
DIESEL ENGINES
|
|
|
1. Remove the vacuum pump of a brake (address to the Head Brake system), fuel atomizers and the fuel pump if has been removed with a head of the block of cylinders and a cam-shaft and pushers. |
|
ALL ENGINES
|
|
|
|
1a. By means of a stripper by turns compress springs of valves and take crackers. |
|
|
1b. Then release a stripper and uncover, a spring. |
|
|
1c. Remove a spring support (address to illustrations). |
|
|
2a. Remove маслоотражательный a cap from the top part of the directing plug of the valve. |
|
|
2b. Then remove the valve through the combustion chamber (address to illustrations). |
|
|
3a. Very important valves and the connected components to store together in correct sequence if they are used further. |
|
|
3b. For this purpose place them in the marked polyethylene bags (address to illustrations). |
|
|
|
|
