Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
- Engine repair
   + Repair of petrol engines of 1.4 l and 1.6 l in an impellent compartment
   + Repair of petrol engines of 2.0 l in an impellent compartment
   + Repair of the diesel engine in an impellent compartment
   - Procedures of removal and engine major repairs
      Methods of removal of the engine and precaution
      Removal and installation of the petrol engine and manual transmission
      Removal and installation of the petrol engine and automatic transmission
      Removal and installation of the diesel engine and transmission
      Sequence of dismantling - an engine partition
      Dismantling of a head of the block of cylinders
      Cleaning, survey and service of a head of the block of cylinders and valves
      Assemblage of a head of the block of cylinders
      Removal, check of a condition and installation of a flywheel/privodnogo of a disk
      Replacement left (the flywheel/privodnogo of a disk located from outside) an epiploon of a cranked shaft
      Removal and pallet installation картера (only for petrol engines of series К7М with the aluminium pallet)
      Removal and installation of an intermediate shaft
      Removal of assemblage of pistons/rods
      Removal коленвала
      Cleaning and survey of the block of cylinders/kartera and cylinders
      Survey and assemblage of assemblages of pistons/rods
      Survey коленвала
      Survey of radical bearings
      Balance of assembly - an engine partition
      Check of a working backlash of radical bearings and installation коленвала
      Check of a working backlash шатунных bearings and installation - assemblages of pistons/rods
      Start of the engine after a partition
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
3bf7a351




Assemblage of a head of the block of cylinders

 ASSEMBLAGE

1. On engines F8Q if vortical chambers have been removed, establish them on former places.

2a. Grease маслоотражательные caps, then establish from in a head of the block of cylinders.

2b. Pushing their suitable head or the special tool (address to illustrations), be convinced that the cap completely became on the directing plug of the valve.

3. Insert valves on former places. If new valves are established, insert them on those places to which they have been ground in. Do not damage маслоотражательные caps at installation of valves (address to an accompanying illustration).

4. Arrange a spring support on directing, then a spring and a cover.

5. Compress a spring of the valve and insert crackers into dredging in a rod. Release a stripper, then repeat procedure with remained valves. Put a few greasings to keep crackers in a valve flute (address to an accompanying illustration).

6. Having established all valves, put a head of the block of cylinders on a workbench and киянкой strike on the end of a rod of each valve to settle position of components.
7. Now it is possible to establish the components removed earlier listed at paragraphs 1 or 2 Dismantling of a head of the block of cylinders Has undressed.