|
1. Remove a cam-shaft cogwheel as Removal, survey and cogwheel installation drive a belt and the tension mechanism is described in Section.
2. Notice a correct arrangement of an old epiploon. By means of a small screw-driver take an epiploon from a head of the block of cylinders.
3. Rub off a basic surface in a head of the block of cylinders.
|
|
4a. Put an oil small amount on external edge and a sealing edge of a new epiploon. Insert an epiploon into a block head. |
|
|
4b. Hammer in it into place by means of a metal tube or a nest which external diameter hardly is less than diameter of a landing nest of an epiploon in a head of the block of cylinders (address to illustrations). Be convinced that the epiploon is correctly focused, a sealing edge inside. |
5. Establish a cam-shaft cogwheel as Removal, survey and cogwheel installation drive a belt and the tension mechanism is described in Section. |
