Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
- Engine repair
   - Repair of petrol engines of 1.4 l and 1.6 l in an impellent compartment
      Compression check - the description
      Arrangement of the top dead point (ВМТ) the piston №1
      Check and adjustment of backlashes of valves
      Removal, survey and installation gear drive a belt
      Removal, survey and cogwheel installation drive a belt and the tension mechanism
      Replacement of an epiploon of a cam-shaft
      Removal, survey and cam-shaft installation
      Removal, survey and installation of a head of the block of cylinders
      Removal and pallet installation картера
      Removal, survey and installation of the oil pump and cogwheel
      Replacement of epiploons коленвала
      Survey and replacement of support of the engine/transmission
      Removal, survey and installation of a flywheel/privodnogo of a disk
   + Repair of petrol engines of 2.0 l in an impellent compartment
   + Repair of the diesel engine in an impellent compartment
   + Procedures of removal and engine major repairs
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes

Removal, survey and installation of a flywheel/privodnogo of a disk


For removal of a flywheel or drive a disk it is required have gone right engine and transmission assemblage, and then to separate the engine from transmission.

1. Remove a manual transmission or automatic transmission.
2. On models with a manual box of a gear change, remove coupling as Coupling is described in the Head.
3. Note an arrangement of a flywheel/privodnogo of a disk rather коленвала to simplify the subsequent installation. Pay attention that the flywheel/privodnoj a disk can be established only in one position, thanks to non-uniform distance between bolts.
4. The Flywheel/privodnoj is necessary for blocking now a disk, that it was possible to weaken bolts. For this purpose establish a long bolt in one of apertures for bolts of fastening of transmission to the engine and insert a wide screw-driver into a gear wreath of a flywheel.
5. Turn away fixing bolts and remove a flywheel/privodnoj a disk.


1. Examine a gear wreath of a flywheel/privodnogo of a disk. If the gear wreath is worn out or damaged, it probably to replace, but this work it is better to charge HUNDRED Renault or automobile repair shop.
2. Attentively examine a flywheel/privodnoj a disk that there was no deformation, cracks round apertures under bolts or other damages. If damages have been found, приводной the disk should be replaced.
3. Examine contact with a disk of coupling a flywheel surface on presence of scratches. If the surface is strongly developed, a flywheel it is possible перешлифовать, but is better it to replace.


1. Clear contact surfaces of a flywheel/privodnogo of a disk and коленвала, then arrange a flywheel/privodnoj a disk on коленвале, having combined all preliminary made labels.
2. Put some drops taking компаунда on a carving of fixing bolts, establish bolts and tighten them in diagonal sequence the effort resulted in Specifications.
3. Establish a manual transmission or automatic transmission as it is described in the Head Transmission, then establish engine/transmission assemblage in the car.