Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Body and bottom service

The general condition of a body of the car essentially influences its estimated cost. To serve a body simply, but to do it it is necessary regularly. The neglect these procedures, especially after small damage, can quickly lead to considerable deterioration of a body and its expensive repair. It is important to support also in a good condition the latent parts of a body, for example the bottom and internal surfaces of arches of wheels.
The basic procedure of service of a body is the sink a water considerable quantity (from a hose), allowing to remove from the car all stuck dirt and firm particles. It is important to wash off them so that gravel did not scratch colouring. Arches of wheels and the bottom also require a sink - the dirt which has collected on them absorbs a moisture from environment that increases risk of corrosion. It is the most easier to clean the bottom and arches in rainy weather when the mud outgrowth размок and became soft. Sometimes in rainy weather the bottom is cleared itself, and this successful time for survey.
Periodically (except for the cars which bottom is covered by a protective wax layer) clear the bottom ferry. After that make full survey of a body, marking the places demanding small repair. Cleaning by steam is made at many servicing deports and is necessary for removal of oily outgrowths. If such cleaning is not accessible, on sale there are special solvents for removal of similar adjournment. Put solvent by means of a brush, then it is simple смойте a dirt a water stream. This method also cannot be applied to the cars which bottom is covered by a protective wax layer, differently this layer will be removed. Such cars should pass annual survey, in preferably autumn during which time the bottom should be washed up, and a protective layer if it is damaged, restored. It is recommended to inject the same protective wax structure into door panels, thresholds and other cavities of a body, as additional protection against corrosion.
After a sink of the painted surfaces, rub off their suede to add shine. The covering of surfaces a thin layer of a wax polyrole will give additional protection against chemical загрязнителей air. If colouring has grown dull or was oxidised, use a combination of a special cleaner/polyrole to restore shine. It demands some efforts, but similar difficulties arise only if a regular sink neglected. Colouring "metallic" demands the cautious reference - use a special not abrasive cleaner not to damage it. Be convinced that drainage apertures of doors and a tube of waste system are not littered. Windshields and windows should be washed out periodically a screen wiper. Never put on glasses wax polyroles or a polyrole for the chromeplated details of a body.