Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
- Power supply systems, release
   - Fuel and an exhaust system - petrol models
      Removal and installation - assemblage of the air filter and inlet air lines
      The general description of a control system in temperature of air (the central injection)
      Removal, installation and adjustment of a rope of a pedal of gas
      Removal and installation of a pedal of an accelerator
      The general description and use unleaded gasoline
      The general description of system of injection of fuel
      Depressurization of system of injection of fuel
      Removal and installation топливоподкачивающего the pump
      Removal and installation of the gauge of a stock of fuel
      Removal and installation of a fuel tank
      Removal and installation of the case of a throttle
      Check and adjustment of system of injection of fuel
      Removal and installation of components of system of the central injection
      Removal and installation of components of system of the distributed injection
      Removal and installation of the inlet pipeline and final collector
      Removal and installation of final system
   + Fuel and exhaust systems - diesel models
   + Systems of decrease in toxicity of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
3bf7a351




Removal, installation and adjustment of a rope of a pedal of gas

 REMOVAL

1. On engines E7J, remove assemblage of the air filter as Removal and installation - assemblage of the air filter and inlet air lines is described in Section. On all models where it is applied, turn away strengthening core between domes of racks of a forward suspension bracket.

2. On the throttle case, manually turn sector throttle заслонки to weaken a rope tension. Disconnect a rope from sector (address to an accompanying illustration).

3. Remove a casing of a rope and a sealing ring from an arm (address to an accompanying illustration). On models with automatic transmission, disconnect conducting of the gauge of compulsory return switching of transfer from the end of a casing of a rope. If it is necessary, remove spring скобу from the rope end, marking its arrangement in a flute.

4. Working in the car, remove the bottom panel of furnish from under a steering column. Disconnect a rope from a gas pedal, compressing ledges of a tip of a rope (address to an accompanying illustration).

5. Return to an impellent compartment, release a casing of a rope from a partition and take a rope.


 INSTALLATION

1. Make installation in return sequence, if necessary adjust a rope as follows. Adjustment carry out before installation of a strengthening core or assemblage of the air filter.


 ADJUSTMENT

1. Having removed spring скобу from a casing of a rope of an accelerator, check up, that the sector throttle заслонки concerned the terminator. Cautiously pull a rope from a sealing ring, cleaning all люфт a rope.

2a. Having fixed a rope in this position, establish spring скобу in the nearest before a rubber sealing ring and a washer a flute (address to illustrations).

2b. After installation скобы and отпускания a rope casing should be only insignificant люфт a rope.

2c. An arm - engine K7M

At ignition deenergizing the resulting motor of a mode of idling slightly opens throttle заслонку. Люфт a rope should be sufficient that throttle заслонка it could be closed from this position, differently do not receive steady turns of idling.

3. Ask the assistant to press a pedal of gas and check up, that the sector throttle заслонки completely and freely opened and came back to the terminator.