Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
- Power supply systems, release
   - Fuel and an exhaust system - petrol models
      Removal and installation - assemblage of the air filter and inlet air lines
      The general description of a control system in temperature of air (the central injection)
      Removal, installation and adjustment of a rope of a pedal of gas
      Removal and installation of a pedal of an accelerator
      The general description and use unleaded gasoline
      The general description of system of injection of fuel
      Depressurization of system of injection of fuel
      Removal and installation топливоподкачивающего the pump
      Removal and installation of the gauge of a stock of fuel
      Removal and installation of a fuel tank
      Removal and installation of the case of a throttle
      Check and adjustment of system of injection of fuel
      Removal and installation of components of system of the central injection
      Removal and installation of components of system of the distributed injection
      Removal and installation of the inlet pipeline and final collector
      Removal and installation of final system
   + Fuel and exhaust systems - diesel models
   + Systems of decrease in toxicity of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
3bf7a351




Removal and installation of a fuel tank

 REMOVAL

1. Before removal of a fuel tank it is necessary to remove all fuel from it.
2. Remove a back seat or a pillow of a back seat (the Head the Body) to get access to a cover топливоподкачивающего the pump.
3. By means of a screw-driver accurately press a cover to get access to the pump.
4. If in a fuel tank there was a fuel, it can be removed, having disconnected a hose of giving of fuel and having attached to a branch pipe on the pump a hose. Remove the relay топливоподкачивающего the pump, established in the block of safety locks/relays in an impellent compartment (relay "L", the Scheme 1 see), and a crosspiece connect plugs 3 and 5 (plugs to thick wires). Wait, while топливоподкачивающий the pump will not pump out fuel from a tank, then disconnect a crosspiece and establish the relay.
5. Disconnect a socket of electroconducting from топливоподкачивающего the pump and attach it to a car body.
6. Disconnect a cable of weight from the battery (address to the Head the Electric equipment of the engine for models Scenic).

If the autoradio tape recorder in your car is coded before to disconnect the battery, be convinced that you know a code.

7. Disconnect a returnable hose from топливоподкачивающего the pump, address to Section Removal and installation топливоподкачивающего the pump.
8. Block forward wheels, then поддомкратьте a back part of the car and establish on axial props. Remove the right back wheel.
9. Remove an exhaust system and corresponding теплоизоляционный a board, address to Section Removal and installation of final system.
10. Notice position of an adjusting nut on a back part of a core of the equalizer of the lever of a manual brake, then turn on and remove it and separate ropes of a manual brake from holders on the bottom. Displace ropes from a fuel tank.
11. Prop up a tank a jack with laid between them wooden бруском.
12. Turn on and remove fixing bolts, then slowly lower a fuel tank, disconnecting all tubes which become accessible, and remove a tank from under the car. Pay attention that probably it is necessary to bend accurately brake tubes to provide a sufficient backlash at tank lowering.
13. If the tank is polluted by a deposit or water, remove топливоподкачивающий the pump/gauge (Has undressed Removal and installation топливоподкачивающего the pump), and wash out a tank pure fuel. The tank is made of a synthetic material - and if it is damaged, it is necessary to replace it. However in certain cases small leaks probably to eliminate. Address for council to the expert.


 INSTALLATION

1. Make installation in the return to removal an order, paying attention to the following:
a) At tank lifting back into position watch that between a tank and a car body hoses were not jammed.
b) Be convinced that all tubes and hoses are correctly located.
In summary, fill a tank with a small amount of fuel and check up on leak signs.