Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   Prorolling of hydrosystem of brakes
   Replacement of brake tubes and hoses
   Replacement колодок forward brake mechanisms
   Replacement колодок back brake mechanisms
   Survey, removal and installation of a disk of the forward brake mechanism
   Removal, survey and installation of drums of back brake mechanisms
   Removal, partition and installation of supports of forward brake mechanisms
   Removal and installation of the cylinder of the back brake mechanism
   Removal, partition and installation of the main cylinder
   Removal and installation of a pedal of a brake
   Check, removal and installation of the block of the vacuum amplifier
   Removal, check and installation of the unilateral valve of the block of the vacuum amplifier
   Adjustment of a manual brake
   Removal and installation of the lever of a manual brake
   Removal and installation of ropes of a manual brake
   Check, removal and installation of the valve of adjustment of pressure in back brake mechanisms
   Removal, installation and adjustment of the switch of lanterns
   The general description of system of antiblocking of brakes (ABS)
   Removal and installation of components of system ABS
   Removal and installation of the vacuum pump (diesel engines)
   Check of serviceability and partition of the vacuum pump (diesel engines)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
3bf7a351




Removal and installation of the vacuum pump (diesel engines)

 REMOVAL

1. Where it is necessary to facilitate access to the vacuum pump, remove an intaking air line (address to the Head of the Power supply system and release).
2. Let out a collar and disconnect a vacuum hose from the pump.
3. Turn away nuts/bolts, fastening the pump by the left end of a head of the block of cylinders, then remove the pump. Remove a pump lining - it be subject to replacement.


 INSTALLATION

1. Clear and dry up contact surfaces of the pump and a head of the block of cylinders and establish on a head a new lining.
2. Deduce the pump into position, having combined a leading ledge with a cam-shaft groove, then establish fixing nuts/bolts of the pump and tighten them.
3. Connect a vacuum hose to the pump, tighten a collar and establish an intaking air line of the air filter.