Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
- Transmission
+ Manual box of a gear change (Manual transmission)
- Automatic transmission
Filter replacement трансмиссионной liquids
Adjustment of length of a rope of switching of a mode of movement
Removal and installation of assemblage of the lever of a choice of a mode of movement
Removal and installation of a rope of switching of a mode of movement
Removal and installation of a drive of a speedometer
Replacement of epiploons
Removal and cooler installation трансмиссионной liquids
Removal and installation of electronic components of automatic transmission
Removal and installation of automatic transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
|
Removal and installation of electronic components of automatic transmission
|
|
After replacement of any of components of electronic control by transmission it is necessary to reinstall transmission position “without loading / full loading”. The special diagnostic equipment (Renault XR25) For this purpose is required. Charge this work HUNDRED Renault. |
|
|
|
1. Disconnect a cable of weight from the battery (on models Scenic address to the Head an engine Electric equipment).
|
|
If the autoradio tape recorder in your car is coded before to disconnect the battery, be convinced that you know a code. |
|
|
THE MULTIPURPOSE SWITCH
|
|
|
1. The multipurpose switch informs the electronic control mean, what position occupies the lever of a choice of a mode of movement, prevents engine start in all modes, except a movement mode, prevents engine start in all modes, except Р and N, and also operates inclusion of lanterns of a backing. The switch is established on a back part of transmission, above the left power shaft.
2. To remove the switch, track electroconducting going from it to a socket and disconnect it.
3. Turn away a fixing bolt and remove a tightening lath. Turn away a bolt of a cable of weight, then deduce the switch from transmission together with a sealing ring. |
|
POTENTIOMETER ЗАСЛОНКИ OF TRANSMISSION
THE GAUGE OF SPEED
|
|
|
1. The gauge of speed is established on transmission from above.
2. To facilitate access, remove assemblage of the air filter and its fixing arm as it is described in the Head of the Power supply system, release.
3. Track conducting from the gauge and disconnect its socket.
4. Turn away a fixing bolt and remove a tightening lath, then deduce the gauge from transmission together with a sealing ring. |
|
THE PRESSURE GAUGE IN THE HYDROWIRE
|
|
|
1. The pressure gauge in a hydrowire is established in the transmission basis in a forward part of the block.
2. To get access to the gauge, cock a manual brake, then поддомкратьте a forward part of the car and establish it on axial props. Turn away screws of fastening and remove a plastic bottom cover.
3. Track conducting from the gauge and disconnect its socket.
4. Be ready to an exit of a liquid during gauge removal. Turn out bolts and remove a fixing plate of the gauge. Remove the gauge and remove a sealing ring. |
|
ELECTRONIC CONTROL MEAN
|
|
|
1. The electronic control mean (ECU) is in a forward left corner of an impellent compartment where it is attached to the accumulator.
2. Dismiss a rubber fixing belt, then disconnect sockets of electroconducting and take ECU from an impellent compartment. |
|
|
|
|
1. Make installation upside-down. In summary, connect to the accumulator a negative wire and charge to the expert to reinstall transmission position “without loading / full loading”. |
|
|
|
