Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
- Transmission
   + Manual box of a gear change (Manual transmission)
   - Automatic transmission
      Filter replacement трансмиссионной liquids
      Adjustment of length of a rope of switching of a mode of movement
      Removal and installation of assemblage of the lever of a choice of a mode of movement
      Removal and installation of a rope of switching of a mode of movement
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and cooler installation трансмиссионной liquids
      Removal and installation of electronic components of automatic transmission
      Removal and installation of automatic transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes

Replacement of epiploons

DIFFERENTIAL EPIPLOON

REPLACEMENT

1. Cock a manual brake, then поддомкратьте a forward part of the car and establish it on axial props. Remove a wheel.
2. Address to the Head Power shafts and separate assemblage of a power shaft from transmission. Notice that there is no necessity to remove a power shaft completely, the shaft can be left attached to nave assemblage.

3. Accurately wring out a casing of an epiploon from an external wall картера transmissions (address to an accompanying illustration).

4. Rub off an epiploon and a casing and mark depth of landing of an epiploon in картере. Accurately wring out an old epiploon by means of a small screw-driver (address to an accompanying illustration). Thus there will be some loss of a liquid - substitute under an aperture the suitable container.

5. Rub off walls of an adjusting aperture in картере and oil a sealing edge of an epiploon. Accurately spread a new epiploon on a shaft of a lateral gear wheel of differential a sealing edge inside. Push an epiploon into position (on the depth measured before removal), having rested against its firm external edge a piece of a metal tube or a head.
6. Establish a new casing of an epiploon.
7. Establish power shaft assemblage as it is described in the Head Power shafts.
8. Check up and if it is necessary, finish to norm oil level in the block of the main transfer (address to the Head Maintenance service).
9. Establish a wheel, lower the car on the earth and tighten wheel bolts the effort resulted in Specifications.

SEALING RING OF THE BEARING OF DIFFERENTIAL

REPLACEMENT

1. Procedure of replacement of sealing rings means removal of nuts of a preliminary tightness of the bearing, therefore it is recommended to charge this work HUNDRED Renault.

HYDROTRANSFORMER CONSOLIDATION

REPLACEMENT

1. Separate transmission from the engine (address to Section Removal and installation of automatic transmission).
2. Remove a fixing belt and accurately remove the hydrotransformer from a transmission shaft. Be ready to a liquid exit.
3. By means of a screw-driver accurately wring out consolidation from the hydrotransformer, trying not to scratch a wall.
4. Establish new consolidation into position, having turned its sealing edge inside.
5. Grease an edge of consolidation pure трансмиссионной with a liquid and accurately establish the hydrotransformer on a transmission shaft.
6. Be convinced that the hydrotransformer is correctly hooked with grooves of a shaft of transmission, then establish transmission (address to Section Removal and installation of automatic transmission).