Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
- Transmission
   + Manual box of a gear change (Manual transmission)
   - Automatic transmission
      Filter replacement трансмиссионной liquids
      Adjustment of length of a rope of switching of a mode of movement
      Removal and installation of assemblage of the lever of a choice of a mode of movement
      Removal and installation of a rope of switching of a mode of movement
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and cooler installation трансмиссионной liquids
      Removal and installation of electronic components of automatic transmission
      Removal and installation of automatic transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
3bf7a351




Adjustment of length of a rope of switching of a mode of movement

 ADJUSTMENT

1. Cock a manual brake, then поддомкратьте a forward part of the car and establish it on axial props. Remove термоизоляционные boards to get access to assemblage of the mechanism of a choice of transfer.
2. Remove the central console as it is described in the Head the Body.
3. Remove assemblage of the air filter (address to the Head of the Power supply system, release).
4. Disconnect a rope of switching of a mode of movement from the transmission lever, having let out скобы and having removed a tip from the hinge.
5. Be convinced that the rope is attached to lever assemblage as it is required, then turn blocking ring of a rope to liberate the adjusting plug.
6. Place the lever of a choice of a mode of movement and the lever on transmission in position of 1st transfer.
7. Put a rope tip to the hinge on transmission (but not насаживайте it at this stage) and be convinced that components are combined as it is required. If it not so, adjust length of a rope, turning the plug. Upon termination of, establish a tip on the hinge and block the adjusting plug, having turned a ring.
8. Establish fixing скобы a rope.
9. Establish the central console as it is described in the Head the Body.
10. Be convinced that the lever of a choice of a mode of movement moves freely and that the starter works only in position “P” and “N”. Check up also parking function.
11. Establish термоизоляционные guards, then lower the car on the earth.