Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Removal and installation of components of system of a washer of wind glass / a back door

The tank of a washer of wind glass / a back door

REMOVAL AND INSTALLATION

1. Working in an impellent compartment, turn away a fixing nut/screw (where is available) and remove a jellied mouth of the tank of a washer. 2. Cock a manual brake, then поддомкратьте a forward part of the car and establish it on axial props. Remove the right forward wheel, then turn away screws of fastening and remove the loose leaf of an arch of a wheel. 3. Release fixing скобы and disconnect hoses from connecting муфты the washer pump (where is available). Where there are some hoses, note their installation. 4. Track electroconducting from the pump of a washer to a socket and disconnect it from the main plait. 5. Turn away a fixing nut on a forward part of the tank, then remove it. 6. Make installation upside-down.

The washer pump

REMOVAL AND INSTALLATION

1. Remove the tank as it is described earlier in this Section. 2. Accurately extend the pump from the tank and remove a sealing ring. Смойте the spilt liquid cold water. 3. Make installation upside-down. At installation use a new sealing ring.

The switch of level of a liquid in the washer tank

REMOVAL AND INSTALLATION

1. To get access to the level switch (where is available), cock a manual brake, then поддомкратьте a forward part of the car and establish it on axial props. Remove a forward wheel, then turn away screws of fastening and remove the loose leaf of an arch of a wheel. 2. Disconnect a socket of electroconducting from the switch of level and accurately remove it from the tank. Remove a sealing ring and смойте the spilt liquid cold water. 3. Make installation upside-down. At installation use a new sealing ring.

Nozzles of a washer of a windshield

REMOVAL AND INSTALLATION

1. To get access to washer nozzles open a cowl, then accurately wring out a screw-driver fixing скобы and unbend шумопоглощающую a lining on a cowl cover. Disconnect hoses of a washer from a corresponding nozzle, then press fixing скобы and accurately remove a nozzle from a cowl. 2. At installation reliably connect a nozzle to a hose and press it into a cowl. Check up nozzle functioning.

Nozzle of a washer of a back door

REMOVAL AND INSTALLATION

1. Open the back door opening upwards and separate a sealant from a doorway. 2. Press blocking uvulas and shift with fixing скоб a back part of a ceiling. 3. Wring out a cover screw-driver to hinges of a back door, then accurately unbend a ceiling. 4. Turn away a fixing nut, then remove a nozzle of a washer and consolidation from a roof, having disconnected a hose. 5. Make installation upside-down.