Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Removal and installation of the mechanism of a gear change

Components of draught and the gear change lever

1 — Mobile draught 2 — the Returnable spring 3 — the Casing шарнирного lever and draught knot 4 — the Fixing framework 5 — the gear change Lever 6 — the lever Handle	7 — the Lock ring 8 — the Plug 9 — Raspornaja a lining 10 — Skoba 11 — the Doubled tip of draught

REMOVAL

1. Working in salon, accurately wring out a protective cover of the lever of a gear change from the central console. Pull together the handle from the lever of a gear change and remove it together with a protective cover (address to an illustration above). 2. Cock a manual brake, then поддомкратьте a forward part of the car and reliably establish it on axial props. Remove the bottom guard of the engine, turn away screws of fastening and remove the plastic protective cover located on the basis of transmission. 3. Disconnect and remove теплоизоляционные the boards located under the lever of a gear change. If it is necessary, remove an exhaust system. 4. If the exhaust system is not removed, turn on and remove fixing bolts of a reception pipe and remove arms of rubber pillows. 5. Unhook a returnable spring from draught of a gear change or a floor (address to an accompanying illustration). 6. Turn away a nut, then remove a washer and disconnect draught of a gear change from the lever basis (address to an accompanying illustration). 7. Turn away fixing nuts, fastening a casing шарнирного knot of the lever and bent for to a floor, then lower assemblage and remove it from under the car. If the exhaust system is not removed, displace it aside. 8. Remove a fixing framework. 9. Tighten the gear change lever in a vice which sponges are supplied by soft overlays, then take a lock ring and separate a casing шарнирного knot and a protective cover. 10. To remove draught of a gear change, let out a rubber protective cover and turn away a bolt. Remember a site of the plug and распорной linings. Separate draught from transmission. 11. To separate the doubled tip, mark its position concerning draught, and then ослабьте a bolt. 12. Examine all components on presence of damages and signs of deterioration and replace them as required.

INSTALLATION

1. Grease all шарнирные knots with universal greasing. 2. Establish the doubled tip on draught, using the labels made at its removal, and tighten a coupling bolt the effort resulted in Specifications. If new draught or a tip are established, place last so that the length of a visible site with накаткой made approximately 7.0 - 8.0 mm. 3. Put the doubled tip to the lever of transmission and establish a bolt, having convinced that the plug and распорная a lining are placed correctly. Tighten a bolt the effort resulted in Specifications. 4. Collect components of the lever of a gear change, operating in the return to removal an order. 5. Lift lever assemblage in salon through an aperture in a floor, then establish a framework and screw fixing nuts. Tighten nuts the effort resulted in Specifications. 6. Connect draught of a gear change to the lever basis, having checked up an arrangement of plugs and having convinced that the nut costs on the left side. Establish a washer, then tighten a nut the effort resulted in Specifications. 7. Fasten a returnable spring to draught of a gear change. 8. Check up and adjust lever work (address to Section Adjustment of the mechanism of a gear change). 9. Establish теплоизоляционные boards, a plastic cover and the bottom guard of the engine, and also components of final system, then lower the car on the earth.