Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
- Transmission
   - Manual box of a gear change (Manual transmission)
      Oil replacement in transmissions
      Adjustment of the mechanism of a gear change
      Removal and installation of the mechanism of a gear change
      Replacement of epiploons
      Serviceability check, removal and installation of the switch of lanterns of a backing
      Removal and installation of a drive of a speedometer
      Removal and transmission installation
      The general description of a partition of a manual box of a gear change
   + Automatic transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes

3bf7a351 Панели МДФ стеновые орех.

Adjustment of the mechanism of a gear change

Precisely to adjust draught of a gear change, the special tool (Renault B.Vi is required. 1133).


1. Cock a manual brake, then поддомкратьте a forward part of the car and establish it on axial props.
2. Turn away screws of fastening and remove from the transmission basis a protective cover.

3. Choose on transmission 1st transfer, having moved its working lever and corresponding position. To block the transmission lever, establish tool Renault B.Vi. 1133 as shown (address to an accompanying illustration). In the absence of the special tool make suitable replacement of a flat metal core or wooden бруска.

4. With the help probeа be convinced that the backlash (Y) between a ring блокиратора casual inclusion of a backing on the lever of a gear change and an inclined side on the right party of a casing of the lever makes 3 mm (address to an accompanying illustration).

5. If adjustment is necessary, unhook a returnable spring from the end of draught turned to the lever of a gear change, then ослабьте a coupling bolt on the opposite end of draught so that draught could be displaced.
6. Move the gear change lever so that the ring блокиратора casual inclusion of a backing has concerned an inclined side on a casing, then insert between a ring and a side probe in the thickness of 3 mm. Block the lever in this position and tighten a coupling bolt the effort resulted in Specifications.
7. Remove blocking tool, then establish a returnable spring and repeatedly check up a backlash as it is described in paragraph 4.
8. Be convinced that the gear change lever easily moves to each of positions, then establish a protective cover and lower the car on wheels.