Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
- Engine electric equipment
   + Charge and start systems
   + Ignition system - petrol models
   - System of preheat of the diesel engine
      Removal, survey and installation of candles накаливания
      Removal and installation of the block of management by heat system
      Adjustment, check, removal and installation of the microswitch of heat
      Adjustment, check, removal and installation of the microswitch of the conditioner of air
      Check, removal and installation of the gauge of temperature of a cooling liquid
      The general description and replacement of components of system of heating of the fuel filter with heat system
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of the block of management by heat system

ENGINE F8Q 620

REMOVAL

1. The block is on a partition of an impellent compartment (address to an accompanying illustration).

2. Disconnect a cable of weight from the battery.
3. Turn away a fixing nut and remove the block from an arm on a partition.
4. Disconnect conducting from the block basis, marking a socket site.

ENGINE F8Q WITH ТУРБОКОМПРЕССОРОМ

REMOVAL

1. The block is on a partition of an impellent compartment (address to an accompanying illustration).

2. Disconnect a cable of weight from the battery.
3. Turn on and accurately disconnect the multicontact tip from a socket.
4. Turn away two screws of fastening, and remove the block from an arm on a partition.

ENGINE F9Q

REMOVAL

1. The block is in an impellent compartment on a forward right arch of a wheel, near to the fuel filter.
2. Disconnect a cable of weight from the battery.
3. Disconnect the multicontact tip from the block, then turn away screws of fastening and separate the block from an arm.

ALL ENGINES

INSTALLATION

1. Make installation in return sequence, watching that electroconducting sockets have been correctly connected.