Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
- Engine electric equipment
   + Charge and start systems
   - Ignition system - petrol models
      Check of system of ignition
      Removal, check and installation of coils of ignition
      Removal, survey and installation of the distributor (engines E7J)
      Removal and installation of the module-amplifier (engines E7J)
      Removal and installation of the gauge of a detonation
      Check and adjustment of the moment of ignition
   + System of preheat of the diesel engine
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes

Removal, survey and installation of the distributor (engines E7J)


1. Remove air lines of the air filter on the left side of the engine (address to the Head of the Power supply system and release).
2. Turn away screws of fastening and uncover the distributor case. Displace a cover and conducting of spark plugs aside, or if necessary separate wires from a cover, spark plugs and the holder and remove them (address to illustrations).

3. Disconnect бегунок from a shaft of the distributor and remove a plastic guard (address to an accompanying illustration).

4a. By means of a face figured key turn away two fixing bolts.

4b. Disconnect the distributor from a head of the block of cylinders (address to illustrations).

5. Remove consolidation from the distributor basis (address to an accompanying illustration).


1. Check up бегунок the distributor and a distributor cover (address to the Head Maintenance service) and replace them if it is necessary.
2. Check up backlash size between shaft of the distributor and the case. It should not be excessive. Otherwise it is necessary to replace the distributor.
3. Check up a condition of consolidation of the basis of the distributor and replace it if it is necessary.


1. Make installation upside-down. If the distributor cover is subject to replacement, rearrange high-voltage conducting of spark plugs with old on a new cover.